The O/B reversing valve in a heat pump controls the changeover between heating and cooling modes It works by reversing the direction of refrigerant flow, enabling the heat pump to both heat and cool your home.
The Role of the Reversing Valve in Heat Pump Operation
Heat pumps transfer heat between indoor and outdoor environments rather than generating it. Refrigerant is a chemical substance that plays an important role in heat transfer. In cooling mode, it absorbs heat from inside, while in heating mode, the flow of refrigerant is reversed and it takes heat from the outdoor air.
The essential component that enables the heat pump’s dual functionality is the O/B reversing valve. This valve acts as a traffic director for the refrigerant flow, allowing the system to seamlessly switch between modes. It is controlled by the electrical signal from the thermostat and is located at the outdoor unit (condenser). It connects to refrigerant lines inside the condenser’s cabinet.
- In cooling mode, the valve directs the hot, compressed refrigerant to the outdoor coil, where the heat is released, effectively cooling the indoor environment.
- In heating mode, the valve is energized to reverse the flow, directing the hot, compressed refrigerant to the indoor coil. Here, heat is absorbed from the outside air and released inside the home, allowing the system to maintain the desired temperature year-round.
A properly functioning reversing valve is essential for efficient operation. It ensures proper refrigerant routing, prevents issues such as freeze-ups, supports system longevity, and protects the compressor from damage.
O/B Wiring
The O/B wire is usually orange in color. It is connected to the thermostat terminal labeled O/B, O, or B, depending on the system. Some thermostats may have separate O and B terminals.
When setting up your thermostat, it will ask if your heat pump reversing valve energizes on cool (O) or heat (B).
- On Cool
The thermostat will energize the reversing valve during a cooling cycle. - On Heat
The thermostat will energize the reversing valve during a heating cycle.
Most heat pumps energize the reversing valve on cool settings.
Proper O/B wiring ensures the heat pump changes modes correctly. Incorrect wiring can cause the system to heat when it should cool or run in cool mode when it should be heating.
